Metrohm tiamo 2.3 (process analysis) - Manual (Page 1708)

8.4 Manual control - Functions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1692 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Selection ACTIVE | INACTIVE | ERROR
[Start]
Sets the stepping motor to ACTIVE.
[Stop]
Sets the stepping motor to INACTIVE.
Reset
On this tab the motor control can be reset to factory settings.
Port description
Display of the port description.
Port
Display of the internal description of the port.
Type
Display of the port type.
Timeout
Time in seconds or minutes within which the action must have run
through completely. If this is not done after the maximum waiting time
has expired, the status of the stepping motor will be set to ERROR.
Range 0 ... 999999
Default value 10
Selection s | min
Default value s
Status
Display of the current status.
Selection ACTIVE | INACTIVE | ERROR
[Set]
Resets the stepping motor to factory settings.
Graphical display
Besides the stepping motor, the assigned inputs and outputs are also dis-
played.