Metrohm tiamo 2.3 (process analysis) - Manual (Page 334)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
318 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
￭ Statistically linked determinations
If determinations are selected for reprocessing that are statistically
linked with other determinations that have not been selected then
these determinations will also be automatically reprocessed when sav-
ing and then saved as new versions. Determinations that are statisti-
cally linked with each other must always be reprocessed in the same
sequence as they were recorded. If no modification is made to a deter-
mination then this determination will retain its original determination
status (i.e. original for non-modified determinations).
Note
If the selected determination belongs to a statistics series still running,
the results modified during reprocessing will not be taken into account
in the automatically generated reports of the following determinations
of the statistics series.
In this case, the end of the statistics series has to be waited for. After
this, all determinations of the statistics series contain the right results
and the original reports can be printed from the database.
￭ Start test
During the start test all device tests and device monitoring will be
ignored.
￭ Special tracks
During reprocessing the series start, series end and error tracks are not
run through again.
￭ Tracks with "Return immediately"
If the method contains tracks with the option Return immediately
enabled, then a warning will appear, that it can no longer be guaran-
teed that the method will proceed in the same way during reprocess-
ing as during the determination itself.
￭ Monitoring If the method contains monitoring of variables and results
then the corresponding messages will be shown and included in the
report, but no e-mails will be sent nor will beeps be produced. If one
of the two actions Stop determination or Stop determination and
series is enabled, then reprocessing will be canceled.
￭ Titration and measuring commands
For DET, MET, SET, KFT, KFC, MEAS, CAL MEAS only the evaluations
with existing data will be recalculated, all other parameters will be
ignored. For commands that generate data, which are carried out dur-
ing the determination but are no longer carried out during reprocess-
ing, all the existing values will be deleted. If commands that generate
data are carried out for the first time during the recalculation then the
recalculation will be canceled.