Metrohm tiamo 2.3 (process analysis) - Manual (Page 346)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
330 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Start value
Initial value for scaling the y-axis.
Only editable when the option Autoscaling is disabled.
Range
-1.0E12 ... 1.0E12
Default value -1.0E12
End value
End value for scaling the y-axis.
Only editable when the option Autoscaling is disabled.
Range
-1.0E12 ... 1.0E12
Default value 1.0E12
Curve
Curve color
Selection of the color for the curve line.
Selection 13 colors | blue
Default value blue
Symbol
Selection of the symbol for the display of the individual measuring points.
Selection 5 symbols | No symbol
Default value No symbol
No symbol
Measuring points are not shown.
Note
With curves, for which the distance between to measuring points is
smaller than 5 pixels, the separate measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can eventually be enlarged in order to display the symbols
again.
Symbol color
Selection of the color for the measuring point symbol.
Selection 13 colors | blue
Default value blue