Metrohm tiamo 2.3 (process analysis) - Manual (Page 65)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 49
Designation Description Commands
.SAN Current, absolute swing angle of
the robotic arm in ° (entry upon
ending the command) MOVE, SWING
.SLO Electrode slope of the sensor used
for the command (in % for pH
sensor or mV for ISE sensor) or
electrode slope calculated from
the calibration (for STDADD and
CAL LOOP) DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS T,
MEAS Conc,
STDADD, CAL
LOOP, DOS, ELT
LOOP
.SME Start measured value (measured
value after processing the start
conditions) in the unit of the
measured value DET, MET, SET,
KFT, KFC, BRC,
STAT
.SPO Current external position (entry
when ending the command); 0
means invalid position SWING
.STC {x} Concentration of standard x (1...
50) used for the command CAL LOOP Opt
.STE Start temperature (temperature
after processing of the start condi-
tions) in °C DET, MET, SET,
KFT, KFC, BRC,
STAT
.STY Type of stop with which the com-
mand was stopped: 1 = normal;
0 = manual or after error DET, MET, SET,
KFT, STAT, MEAS,
CAL Cond, CAL
MEAS, CAL Spec,
STDADD, DOS,
ELT MEAS
.SVA Start volume absolute (volume
that was added according to the
start condition "start volume") in
mL DET, MET, SET,
KFT, STAT
.SVM Start volume measured value (vol-
ume which was added according
to the start measured value given
in the start conditions) in mL DET, MET