Metrohm tiamo 2.3 (process analysis) - Manual (Page 1542)

7.9 774 Oven Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1526 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
￭ Dosing device
Properties of the connector and the dosing devices connected to. This
tab is only displayed if the Oven Sample Processor is connected to the
PC via an RS-232 interface.
￭ Oven
Shows the oven parameters. This tab is only displayed if the Oven Sam-
ple Processor is connected to the PC via an RS-232 interface.
￭ Gas
Shows the parameters for the gas flow. This tab is only displayed if the
Oven Sample Processor is connected to the PC via an RS-232 interface.
￭ RS-232
Selection of the serial interface the device is connected to.
￭ GLP
Information on GLP tests and GLP monitoring.
7.9.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
On the tab General, general properties of the device are displayed.
Device name
Designation of the device (can be freely defined by user).
Input 50 characters
Default value Device type number_#
Device type
Display of the device type.
Program version
Shows the program version of the device.
Only visible with devices that have their own firmware.
[Update]
Opens the dialog window Load new program version (see Chapter
7.1.6, page 1488).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.