Metrohm tiamo 2.3 (process analysis) - Manual (Page 1040)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1024 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Open the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 929).
[Properties]
Open the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 929).
[Delete]
Delete the external measured value selected in the table.
5.6.4.10.6 MEAS Cond - Fixed endpoint evaluation
Dialog window: Method ▶ MEAS Cond ▶ Properties... ▶ Additional evalua-
tions ▶ Fixed endpoint evaluation #
Measured quantity
Selection of the fixed measured quantity to which the associated values
for the other quantities are to be interpolated from the list of measured
points.
Selection Measured value | Time
Default value Measured value
Fixed value
Value of the fixed endpoint.
Measured value
Range
0.0000 ... 2000.00 mS/cm
Time
Range
0.0 ... 999999.9 s