Metrohm tiamo 2.3 (process analysis) - Manual (Page 962)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
946 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Time
Range
0.0 ... 999999.9 s
5.6.4.4 MEAS U
5.6.4.4.1 MEAS U - Overview
Dialog window: Method ▶ MEAS U ▶ Properties... ▶ MEAS U - 'Command name'
Command for potentiometric voltage measurements.
Instruments
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 841, 842, 857, 888, 901, 902, 904, 905,
906, 907
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798,
799
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS U are configured on the follow-
ing 4 tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Defining further methods for evaluating measurement curves.
￭ Additional measured values
Defining further measured values which can be saved as additional col-
umns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command MEAS U and can be used in formulas under the designation
'Command name.Variable designation':