Metrohm tiamo 2.3 (process analysis) - Manual (Page 304)

4.4 Templates ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
288 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
– <detectorType> ... </detector-
Type> Detector type of spectrometer.
– <dateRecDarkRefSpec> ... </
dateRecDarkRefSpec> Recording time of dark and reference spectrum.
– <userRecDarkRefSpec> ... </
userRecDarkRefSpec> User during recording of the dark and the reference
spectrum.
– <methodRecDarkRefSpec> ...
</methodRecDarkRefSpec> Method during recording of the dark and the reference
spectrum.
– <detIDRecDarkRefSpec> ... </
detIDRecDarkRefSpec> Determination ID of the recording of the dark and refer-
ence spectrum.
– <calibDate> ... </calibDate> Calibration date.
– <calibUser> ... </calibUser> User during calibration.
– <calibMethod> ... </calibMe-
thod> Calibration method.
– <calibDetID> ... </calibDetID> Determination ID of calibration.
– <tmfData>
– <valTMF> ... </valTMF> Transmission factor.
– <determDateTMF> ... </
determDateTMF> Calibration date.
– <userNameTMF> ... </userNa-
meTMF> User name.
– <methodNameTMF> ... </
methodNameTMF> Calibration method.
– </tmfData>
– </spectroData>
– <devicePorts dynamic=""> Data on the peripheral devices connected.
– <Port>
<subtype val="" /> Type of the device connected to the port:
XML_PORT_DEVICE_DOS = Dosing/Exchange unit
XML_PORT_DEVICE_REMOTE = Remote Box
XML_PORT_DEVICE_STIR = Stirrer
– <dosPortName> ... </dosPort-
Name> Number of the MSB connector the dosing device was
connected to.
– <dosType> ... </dosType> Dosing device type.
– <dosSerial> ... </dosSerial> Dosing device serial number.