Metrohm tiamo 2.3 (process analysis) - Manual (Page 1070)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1054 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Switch off automatically
on | off (Default value: on)
If this check box is activated, the stirrer will be switched off automatically
when the command has finished.
5.6.4.15.3 MEAS Opt Conc- Measuring parameters
Tab: Method ▶ MEAS Opt Conc ▶ Properties... ▶ Measuring parameters
Command name
Name of the command.
Input 25 characters
Tab for the Avantes spectrometer
The parameters for the measuring procedure can be defined on this tab.
Wavelength
Wavelength at which the measured quantity (absorbance) is recorded
Range 100.0 ... 2000.0 nm
Default value 400.0 nm
Blank value
Value by which the measured quantity (absorbance) is corrected. Here an
expression can also be entered through the formula editor (e.g. xx.EME
from other measuring command) by which every measured absorbance
value can then be corrected.
Range -1E+12 ... 1E+12 (max. 10 digits)
Default value 1.000
Unit
Concentration unit for the blank value.
Input 1 ... 10 characters
Selection mol/L | mmol/L | µmol/L | g/L | mg/L | µg/L |
mg/mL | µg/mL | ppm | % | mEq/L
Default value ppm
Integration time
Integration time for adsorption measurement.
Range 0.01 ... 600000 ms
Default value 6 ms