Metrohm tiamo 2.3 (process analysis) - Manual (Page 1317)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1301
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Note
If the option not defined is selected, then no ports can be selected in
the Stepping motors tab, because it is not known to which device
this block refers.
If a method is generated independently of a device, then a device for
the editing of the block will nevertheless still need to be selected. One
can however afterwards set the device name back to not defined.
Device type
Display of the device type. If a device is selected under Device name,
then this Device type field can no longer be edited, and the device type
belonging to the selected device is displayed instead.
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Stepping Motor Controller
Default value Stepping Motor Controller
5.6.11.6.3 STEPPING MOTOR - Stepping motors
Tab: Method ▶ STEPPING MOTOR ▶ Stepping motors
Table
The actuation of a stepping motor is parameterized in every line of the
Stepping motors table.
One port can not be used more than once within a block.
If a command block originates from a different device, the Port descrip-
tion of which does not exist on the currently selected device, then the
affected lines will be presented in red script.