Metrohm tiamo 2.3 (process analysis) - Manual (Page 928)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
912 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Entry of a waiting period before the start of the titration.
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Entry of criteria which cause the titration to stop.
￭ Thermometric evaluation
Parameters for the thermometric evaluation of titration curves.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration
curves.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional columns in the measuring point
list.
Command variables
The following command variables are generated in the method run by the
command TET and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Designa-
tion Description
BSY Command status; 1 = BUSY, HOLD or ERROR;
0 = READY; invalid (variable not available) =
Command has never been started
CONC Concentration of the solution used for the com-
mand
CYL Cylinder volume of the dosing unit used for the
command
DBL Total duration for the processing of the com-
mand in s
DSC Time for processing all start conditions in s
EME End measured value (measured value after pro-
cessing of the command) in the unit of the meas-
ured value
EP{x}.ERC 2. derivative for the endpoint x (1…9) in the unit
of the measured value
EP{x}.MEA Measured value for the endpoint × (1…9) in the
unit of the measured value