Metrohm tiamo 2.3 (process analysis) - Manual (Page 348)

4.5 Determination overview ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
332 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Command-dependent selection
Selection of the quantity to be shown on the y2 axis.
Label
Freely definable axis label for the y2 axis.
Selection 50 characters | auto
Default value auto
auto
The designation from the field Size will be used.
Curve
Curve color
Selection of the color for the curve line.
Selection 13 colors | red
Default value red
Symbol
Selection of the symbol for the display of the individual measuring points.
Selection 5 symbols | No symbol
Default value No symbol
No symbol
Measuring points are not shown.
Note
With curves, for which the distance between to measuring points is
smaller than 5 pixels, the separate measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can eventually be enlarged in order to display the symbols
again.
Symbol color
Selection of the color for the measuring point symbol.
Selection 13 colors | red
Default value red
Smoothing
Smoothing
on | off (Default value: on)
Switches smoothing on/off for the curve.