Metrohm tiamo 2.3 (process analysis) - Manual (Page 1367)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1351
6.3.3.1.2 Editing custom calibration buffers
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Custom calibration buf-
fer ▶ [Edit] ▶ Change pH value
In the dialog window Change pH values you can edit the pH values for
the buffer selected in the buffer table.
Temperature
Selection of the temperature for which the pH value is to be edited.
Range 0 ... 95 °C
pH value
pH value of the buffer for the selected temperature.
Range -20.000 ... 20.000
Selection off
Default value off
Note
For your own calibration buffers you should enter the pH values for the
temperature range in which your pH calibration and pH measurement
will later be carried out. If you do not know the pH values at individual
temperatures, they will be calculated automatically by linear interpola-
tion.
6.3.3.2 Templates - Input lines
6.3.3.2.1 Managing templates for input lines
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Input lines ▶ Templates for
input lines
In the dialog window Templates for input lines, client-specific bit pat-
terns for scanning remote input signals can be defined which can be
selected with the command SCAN and in Manual Control. The table with
the defined templates cannot be edited, although it can be sorted accord-
ing to the selected column in increasing or decreasing sequence by click-
ing on the column title
[New]
Create a new template (see Chapter 6.3.3.2.2, page 1352).
[Edit]
Edit the selected template (see Chapter 6.3.3.2.2, page 1352).
[Delete]
Delete the selected template.