Metrohm tiamo 2.3 (process analysis) - Manual (Page 1631)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Instruments
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1615
Input 50 characters
Default value AnOut_x_y_z
The following characters must not be part of the
port description: \ , ', ., {, }, [, ].
Port specification
Shows the specifications of the port.
Type
Display of the port type.
Low level (0%)
Display of the lowest analog output value.
This value is read out automatically and depends on the Type.
High level (100%)
Display of the highest analog output value.
This value is read out automatically and depends on the Type.
Unit
Display of the unit of the analog output value.
This value is read out automatically and depends on the Type.
Note
With the aid of the following parameters the physical values that are
applied to the analog output can be mapped to any measured value.
The transfer function is linear.
0% Mapping
Range -214783648.000 ... 214783647.000
Default value 0
100% Mapping
Range -214783648.000 ... 214783647.000
Default value 100
Unit
Unit of the measured value to be used.
Input 50 characters
Default value %