Metrohm tiamo 2.3 (process analysis) - Manual (Page 1029)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1013
Designation Description
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1…3) for the last measuring point
on the measuring point list
.LP.EXx External value × (1…3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.MA.MEA Maximum measured value (U
ind
) in mV
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MI.MEA Minimum measured value (U
ind
) in mV
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.RTE Reference temperature in °C
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
.TC.TC Temperature coefficient in %/°C
.TC.CO Coefficient c0 of the Chebyshev polynomial of the solu-
tion used
.TC.C1 Coefficient c1 of the Chebyshev polynomial of the solu-
tion used
.TC.C2 Coefficient c2 of the Chebyshev polynomial of the solu-
tion used
.TC.C3 Coefficient c3 of the Chebyshev polynomial of the solu-
tion used