Metrohm tiamo 2.3 (process analysis) - Manual (Page 1137)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1121
5.6.5.10 CAL LOOP Opt
5.6.5.10.1 CAL LOOP Opt - Overview
Dialog window: Method ▶ CAL LOOP Opt ▶ Properties... ▶ CAL LOOP Opt - 'Com-
mand name'
Loop command for the calibration of colorimetric sensors, used
together with the command CAL MEAS Opt.
The number and type of the standards which are to be measured with the
command CAL MEAS Opt is defined in this loop command. After each
looping pass, the validity of the concentration measurement is checked,
and at the end the calibration data for the colorimetric sensor is calcula-
ted.
Appearance
The command has the following appearance:
Parameters
The parameters for the command CAL LOOP Opt are configured in the
following dialog window:
￭ CAL LOOP Opt - Properties
Command variables
The following command variables are generated in the method run by the
command CAL LOOP pH and can be used in formulas under the desig-
nation 'Command name.Variable designation':
Designa-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.C0 Coefficient c0 calculated from the calibration
.C1 Coefficient c1 calculated from the calibration
.C2 Coefficient c2 calculated from the calibration
.C3 Coefficient c3 calculated from the calibration