Metrohm tiamo 2.3 (process analysis) - Manual (Page 1047)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1031
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Open the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 929).
[Properties]
Open the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 929).
[Delete]
Delete the external measured value selected in the table.
5.6.4.12 MEAS Ref
5.6.4.12.1 MEAS Ref - Overview
Dialog window: Method ▶ MEAS Ref ▶ Properties... ▶ MEAS Ref - 'Command
name'
Command for the Measurement of a reference spectrum.
Instruments
This command can be executed with the following device:
Spectrometer: Avantes
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Ref are configured on the fol-
lowing 2 tabs:
￭ General/Hardware
Parameters for device.