Metrohm tiamo 2.3 (process analysis) - Manual (Page 54)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
38 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Designation Description Commands
.BSY Command status; 1 = BUSY,
HOLD or ERROR; 0 = READY;
invalid (variable not available) =
Command has never been started All except START
and END
.C0 Coefficient c0 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C1 Coefficient c1 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C2 Coefficient c2 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C3 Coefficient c3 of the calibration
curve CAL Spec, CAL
LOOP Opt
.CAL Status of the calibration: 1 = cali-
brated normally, 0 = canceled,
because reference wavelength
was not found. CAL Spec
.CBY Command status; 1 = Condition-
ing activated, 0 = Condition-
ing deactivated SET, KFT, KFC,
BRC
.CLC Cell constant of the sensor used in
the command (with conductivity
sensors) MET Cond, MEAS
Cond, CAL Cond
.COD Coefficient of determination (r 2 ),
calculated from calibration func-
tion and confidence interval.
CAL LOOP Opt
.COK Command status; 1 = Condition
requirement fulfilled, 0 = Con-
dition requirement not fulfil-
led SET, KFT, KFC,
BRC
.CONC Concentration of the solution
used for the command DET, MET, SET,
KFT, STAT, ADD,
DOS, LQH,
STDADD
.CP{#}.MEA Measured wavelength of the cali-
bration point in nm. If no meas-
ured peak can be assigned, then
not found will be entered. CAL Spec