Metrohm tiamo 2.3 (process analysis) - Manual (Page 1141)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1125
Designa-
tion Description
.ETE 1) End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE 1) Initial temperature (temperature before start conditions
are processed) in °C
.LP.CNT Transmission of the last measuring point of the measur-
ing point list in %
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.LP.TRN Transmission of the last measuring point of the measur-
ing point list in %
.MTE Temperature measurement with sensor; (1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
1) Command variable is invalid for the Avantes spectrometer
5.6.5.11.2 CAL MEAS Opt - General/Hardware
Tab: Method ▶ CAL MEAS Opt ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.