Metrohm tiamo 2.3 (process analysis) - Manual (Page 1576)

7.13 864 Balance Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1560 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Input 1000 characters
Default value empty
7.13.3 Properties - Tower #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Tower #
On the tab Tower the properties of the tower and of the robotic arm
connected to are displayed.
Tower parameters
Max. stroke path
Entry of the lowest permitted lift position. A lift height of 0 mm corre-
sponds to the "Home position", i.e. the lift is moved right to the top.
Range 0 ... 235 mm
Default value 235 mm
Min. beaker radius
Definition of the minimum radius which the beakers used on the rack
must have. If the lift is moved to the work position the beaker radii
defined in Rack table(see Chapter 6.12.2.1, page 1473) for general
Sample positions(see Chapter 6.12.3.2, page 1476) and Special beak-
ers(see Chapter 6.12.3.4, page 1478) will be compared with the Min.
beaker radius. If this minimum beaker radius is undercut then the run
will be stopped and an error message will appear. With off no check will
be made.
Selection 1.0 … 100.0 mm | off
Default value off
Lift rate
Lift speed for manual operation.
Range 3 ... 25 mm/s
Default value 25 mm/s
Axial distance
Distance between the axis of rotation of the sample rack and swing axis of
the robotic arm.
Range 100.0 ... 300.0 mm
814 USB Sample Processor XL
Selection
166.0 mm
Default value 166.0 mm