Metrohm tiamo 2.3 (process analysis) - Manual (Page 1507)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Instruments
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1491
[Update]
Opens the dialog window Load new program version (see Chapter
7.1.6, page 1488).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Data storage under legal control
Indicates whether the balance has its own data storage under legal con-
trol.
Only visible and editable with Sartorius balances
Selection
on | off
Default value off
Remarks
Remarks about the device.
Input 1000 characters
Default value empty
7.2.3 Properties - Int. Dosing device D0
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device type' -
'Device name' ▶ Int. Dosing device D0
On the tab Int. Dosing device D0 the properties of the internal dosing
device for the preparing of the dosing device can be set.
Note
The preparing of internal dosing devices connected to a 702, 716,
718, 719, 720, 721, 784, 785, 794, 795, 798 Titrino can only be
triggered on the device itself before starting tiamo.
Request for dosing device preparation
Selection when the request for carrying out a PREP (prepare) (see Chap-
ter 5.6.6.5.1, page 1198) command is to be shown for the internal dosing
device.