Metrohm tiamo 2.3 (process analysis) User Manual
Page 708
Advertising
5.6 Commands
■■■■■■■■■■■■■■■■■■■■■■
692
■■■■■■■■
tiamo 2.3 (for Process Analysis)
Note
This command is used for rapid routine determinations when the end-
point does not change throughout a series or when an excess of
reagent must be avoided.
Commands
Depending on the measured value one of the following four SET com-
mands can be selected:
■
SET pH
Potentiometric pH measurement with pH electrodes (measured quan-
tity pH).
■
SET U
Potentiometric voltage measurement with metal electrodes (measured
quantity voltage U).
Advertising