Metrohm tiamo 2.3 (process analysis) - Manual (Page 153)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 137
Note
Generally speaking, no formula input is possible in these fields.
If the option Comment on modification of sample data (live) is
enabled in the security settings, then a reason and a comment on the
modification must be entered before saving (see Chapter 6.2.2.4, page
1333).
3.6.3.8 Single determination - Determination run
Tab: Workplace ▶ Run ▶ Single determination
A determination that is started on the tab Single determination in the
subwindow Run runs through as follows:
1 - Loading the sample data
The sample data entered for the determination is loaded.
2 - Method selection
The following actions are triggered with method selection:
￭ Method selection without Assignment ID
The method selected in the field Method is loaded.
￭ Method selection by assignment ID
If the option Method selection by assignment ID is enabled in the
properties of the single determination on the tab Process (see Chapter
3.6.3.9.4, page 142), then the method defined in the sample assign-
ment table will be loaded (see Chapter 3.4, page 124).
3 - Start test
The following checks and actions are triggered with start test:
￭ Authorization for carrying out the method?
Check whether the registered user is authorized to carry out the
method required (see Chapter 5.4.2.3, page 428).
￭ Method executable?
Check whether the required method is executable. For methods which
are not executable, a prompt appears to perform the method check
and to modify the method accordingly (see Chapter 5.2.5, page 412).
￭ Check device (modules) and rack
Check whether the instruments (and/or instrument types), device mod-
ules (e.g. measuring input, tower, etc.) and racks required in the instru-
ment-specific commands are present and available and/or assigned. If
the instrument in a command is not yet assigned, then the device
assignment dialog window will open for the assignment of the instru-
ment.