Metrohm tiamo 2.3 (process analysis) - Manual (Page 1062)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1046 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Temperature
Measuring temperature which can be entered manually. If a temperature
sensor is connected and the Temperature measurement is set on the
General/Hardware tab under Sensor to continuous, then the temper-
ature will be measured continuously.
Range 20.0 ... 60 °C
Default value 25.0 °C
5.6.4.14.4 MEAS Opt - Evaluations
Tab: Method ▶ MEAS Opt ▶ Properties... ▶ Evaluations
Command name
Name of the command.
Input 25 characters
The following additional methods for evaluation of measurement curves
can be activated and defined on this tab.
Fixed endpoint evaluation
Fixed endpoint evaluation
on | off (Default value: off)
If this option is activated, then the associated values for the other meas-
ured quantities will be interpolated with a fixed measured quantity
(Measured value or Time) for the fixed endpoint from the measuring
point list.
Moves the selected line up (changes the sequence).
Moves the selected line down (changes the sequence).
[New]
Open the dialog window Fixed endpoint evaluation # to enter a new
fixed endpoint (see Chapter 5.6.4.14.6, page 1050).
[Properties]
Open the dialog window Fixed endpoint evaluation # to edit the fixed
endpoint selected in the table (see Chapter 5.6.4.14.6, page 1050).
[Delete]
Delete the selected line.