Metrohm tiamo 2.3 (process analysis) - Manual (Page 719)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 703
5.6.3.4.3.4 SET pH - Control parameters
Tab: Method ▶ SET pH ▶ Properties... ▶ Control parameters
Command name
Name of the command.
Input 25 characters
The control parameters can be set for each endpoint separately.
Endpoint 1
EP1 at pH
Measured value for the first endpoint.
Titrando, 855
Range
-20.000 ... 20.000
Selection off
Default value off
Titrino
Range
-20.00 ... 20.00
Selection off
Default value off
Titration rate
Titration rate
The three predefined sets of parameters can be selected for the titration
rate: slow, optimal and fast; the parameters for Control are not dis-
played. The User setting must be selected in order to be able to edit these
parameters.
Selection slow | optimal | fast | User
Default value optimal
slow
For titrations in which the finest details are also to be visible. This could
however also lead to an increase in noise, which could result in unwan-
ted EPs.
optimal
Parameter set for all standard titrations; optimized for the most fre-
quent applications.
fast
For less critical, fast titrations.
User
Editing the individual titration parameters which affect the titration
rate.