Metrohm tiamo 2.3 (process analysis) - Manual (Page 1492)

6.12 Subwindow Rack data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1476 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
read in by the Sample Processor in order to recognize the rack. If no rack
is in position then the display will be empty.
Number of positions
Shows the number of positions on the rack. If no rack is in position then
the display will be empty.
The parameters for the rack in position are defined in the following tabs:
￭ Rack parameters
Defines the parameters that are valid for all rack positions.
￭ Lift positions
Defines the work, rinse, shift and special positions for Tower 1 and
Tower 2 (if present).
￭ Special beakers
Special beaker Settings for all special beakers on the rack in position.
6.12.3.2 Properties - Rack parameters
Tab: Configuration ▶ Rack data ▶ [Edit] ▶ Properties... ▶ Rack data ▶ Rack
parameters
Beaker radius samples
Radius of the sample beakers on the rack. If the lift is moved to the work
position then this value will be compared with the parameter Min.
beaker radius (see Chapter 7.10.3, page 1534) that can be specifically
defined for each tower. If Beaker radius samples < min. beaker
radius then a corresponding error message will appear. With off the
beaker radius will not be checked.
Range 1.0 ... 100.0 mm
Selection off
Beaker sensor
When a sample position is moved to with the command MOVE then the
beaker sensor (Tower, Robotic arm) checks whether the special beaker
is present or not. With off no check will be made. For the option Robotic
arm a swing head with beaker sensor must be installed and a suitable
work position with beaker contact must be defined for the lift, as this
must move to the beaker recognition position.
With the parameter Beaker test in the command MOVE you can deter-
mine whether the determination is to be terminated if a beaker is missing
with or without the display of a corresponding message and whether the
series is to be continued or also terminated.
Selection Tower | Robotic arm | off