Metrohm tiamo 2.3 (process analysis) - Manual (Page 1066)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1050 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
[Properties]
Open the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 929).
[Delete]
Delete the external measured value selected in the table.
5.6.4.14.6 MEAS Opt - Fixed endpoint evaluation
Dialog window: Method ▶ MEAS Opt ▶ Properties... ▶ Evaluations ▶ Fixed - End-
point - Evaluation #
Measured quantity
Selection of the fixed measured quantity to which the associated values
for the other quantities are to be interpolated from the list of measured
points.
Selection Measured value | Time
Default value Measured value
Fixed value
Value of the fixed endpoint.
Measured value
Range
0 ... 4000 mAU
Time
Range
0.0 ... 999999.9 s
5.6.4.15 MEAS Opt Conc
5.6.4.15.1 MEAS Opt Conc- Overview
Dialog window: Method ▶ MEAS Opt Conc ▶ Properties... ▶ MEAS Opt Conc-
'Command name'
Command for concentration measurements (direct measurement)
with spectrometer or photometer.
Instruments
This command can be executed with the following devices:
Spectrometer: Avantes
Photometer: 089
Appearance
The command has the following appearance: