Metrohm tiamo 2.3 (process analysis) - Manual (Page 1313)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1297
Set default
Writes the content of the Default value field from the configuration
on the analog output.
Value
Mapped value which is to be written on the analog output. A fix value or
a formula (formula editor, CTRL F or right mouse button) can be entered.
Mapping range and unit of the value are defined in the configuration of
the analog output.
If the value that is to be written is less than 0% mapping, then the small-
est possible value (low level (0%)) will be output; in the case of values
greater than 100% mapping, the largest possible value (high level
(100%)) will be output.
5.6.11.5 ANALOG IN
5.6.11.5.1 ANALOG IN - Overview
Dialog window: Method ▶ ANALOG IN ▶ Properties... ▶ ANALOG IN - 'Command
name'
Devices
This command can be executed with the IO Controller.
Appearance
The command has the following appearance:
Mode of operation
The statuses of all analog inputs will be entered and saved in command
variables at the time of the command.
Parameters
The parameters for the command ANALOG IN are configured on the fol-
lowing 2 tabs:
￭ General
Parameters for device.
￭ Stop criteria
Parameters for the definition of the stop criteria.
Command variables
The following command variables are generated in the method run by the
command ANALOG IN and can be used in formulas under the designa-
tion 'Command name.Variable designation':