Metrohm tiamo 2.3 (process analysis) - Manual (Page 409)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 393
Smoothing factor y-axis
Factor for smoothing on the y axis.
Range 0.01 ... 1000
Default value 0.01
4.8.4.5 Curve properties - Options
Tab: Database ▶ Curves ▶ Properties curves # ▶ Options
Options for the graphical display of curves.
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved
per curve window and per client.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS TMF | MEAS Spec
| MEAS Opt | CAL Spec | KFT | KFC | BRC | STAT
| DOS | TET
Default value DET
Note
When the dialog window is opened, those Command type will be
selected per default which applies for the curve shown in the curve
window.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be
scaled automatically. In this case the fields Start value and End value
cannot be edited.
Displaying the grid
Display grid
on | off (Default value: off)
If this check box is activated then a grid will be shown against the back-
ground.
Grid type
Selection of the type of grid line.