Metrohm tiamo 2.3 (process analysis) - Manual (Page 1401)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1385
6.5.2.2 Adding a new device
Menu item: Configuration ▶ Devices ▶ [Edit] ▶ New...
Devices that are connected to the PC via an RS-232 interface must be
added manually to the device table with [Edit]
▶ New.... This opens the
dialog window Device selection.
The required new device must be selected from the tree-form list that is
shown, which contains all the devices known to the program (arranged
according to device type). When the dialog window has been closed with
[OK] the Properties window opens automatically for entering additional
device data.
After the properties window has been closed the new device with its set
parameters is entered in the device table and the connection is tested. If
the connection is ok, then the further device information is read in from
the device.
6.5.2.3 Deleting a device
Menu item: Configuration ▶ Devices ▶ [Edit] ▶ Delete
With [Edit] ▶ Delete, the device selected in the device table is deleted.
Note
Only devices that are not connected can be deleted.
6.5.2.4 Devices - Column display
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Column display... ▶ Column dis-
play
With [Edit] ▶ Column display..., the dialog window Column display is
opened. Here you can define the columns that are to be shown in the
device table.
Columns available
Display of all the fields that can be shown as columns in the device table.
Columns displayed
Display of all the fields that will be shown as columns in the device table.
Per default, the columns Device name, Device type, Device serial
number, Status, Set to work, Next GLP test and Remarks are dis-
played. The columns Device name and Device type are always present
and cannot be removed.
Add the selected column to the table.