Metrohm tiamo 2.3 (process analysis) - Manual (Page 1428)

6.7 Subwindow Sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1412 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Device
Name of device the sensor is connected to.
Measuring input
Device and measuring input the sensor is connected to. In the case of
intelligent sensors, the device and the measuring input are displayed with
green lettering.
Set to work
Date on which the sensor was used for the first time.
Expiry date
Expiry date of the sensor. If sensor monitoring is switched on and if the
set date is before the current date (i.e. the working life has elapsed) then
the date will be shown in red.
Slope
Slope of the sensor in % or mV.
pH(0)/E(0)
Electrode zero point of the sensor.
Next calibration
Date on which the next calibration is to be carried out. If calibration data
monitoring is switched on and if the set date is before the current date
(i.e. the calibration has not yet been carried out) then the date will be
shown in red.
Additional columns from the Sensor properties can be displayed with the
menu item Edit
▶ Column display.
Note
Lines that contain red entries will also show the line number with a red
background.
Table view
The sensor table cannot be edited directly. With a click on the column title
the table can be sorted according to the selected column in either increas-
ing or decreasing sequence. The table view can be adapted with the left-
hand mouse button as follows:
￭ Drag the margin between column titles:
Sets the column width