Metrohm tiamo 2.3 (process analysis) - Manual (Page 842)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
826 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Designation Description
.EP.TIM Time in s until the endpoint is reached
.EP.TIM Time in s until the endpoint is reached
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) = Com-
mand has never ended
.FP{x}.CHA Charge for the fixed endpoint × (1…9) in mA·s
.FP{x}.DVT Drift for the fixed endpoint × (1…9) in µg/min
.FP{x}.MEA Measured value for the fixed endpoint × (1…9) in the
unit of the measured value
.FP{x}.QTY Measured value (water) for the fixed endpoint × (1…9)
in µg
.FP{x}.TEM Temperature for the fixed endpoint x (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1…9) is reached
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.CHA Charge for the last measuring point of the measuring
point list in mA s
.LP.DVT dV/dt for the last measuring point on the measuring
point list (SET, STAT, DOS) or drift for the last measur-
ing point on the measuring point list in µg/min (KFC)
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.IGE Current pulsed current for the last measuring point in
the measuring point list in mA
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.QTY Measured value (water) for the last measuring point in
the measuring point list in µg