Metrohm tiamo 2.3 (process analysis) - Manual (Page 1404)

6.6 Subwindow Titrants/Solutions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1388 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
6.6 Subwindow Titrants/Solutions
6.6.1 Titrants/Solutions - General
Subwindow: Configuration ▶ Titrants/Solutions
Subwindow Titrants/Solutions
The subwindow Titrants/Solutions contains the solution table with all
automatically recognized and manually added titrants and auxiliary solu-
tions. It can be shown in a separate window in the program part Config-
uration as a part of the Configuration view or (if not present on the desk-
top) with View
▶ Quick access. The subwindow can be enlarged and
reduced as required; it can also be maximized.
Titrants
Titrants are used as solutions for the titration commands DET, MET, SET,
KFT and STAT. They can be used in exchange units or dosing units.
Auxiliary solutions
Auxiliary solutions are used as solutions for the dosing commands ADD,
DOS and LQH. They can be used in exchange units or dosing units.
Intelligent exchange units (IEU) and dosing units (IDU)
Intelligent exchange and dosing units have a data chip with stored solu-
tion data. When mounted on intelligent devices (e.g. Titrando) they are
recognized automatically and stored in the solution table.
Non-intelligent exchange units (EU) and dosing units (DU)
Non-intelligent exchange and dosing units must be added manually to the
solution table.
6.6.2 Solution table
6.6.2.1 Solution table
Subwindow: Configuration ▶ Titrants/Solutions
Contents
In the solution table the following information about automatically recog-
nized or manually added solutions is shown as standard:
Solution name
Name of the solution.
Concentration
Concentration (value and unit) of the solution.