Dell PowerEdge VRTX - Manual (Page 112)

Initial Default. SNMP Alert;#EMAIL Alert;#LC Log;#Remote System Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE TRUE TRUE FALSE FALSE FALSE FALSE
CMC8514
Message Fabric mismatch is detected in the I/O Module arg1 .
Arguments
• arg1 = iom slot name
Detailed
Description This error may occur due to any of the following conditons 1) Invalid I/O Module and mezzanine
card configuration, where a newly installed I/O Modules fabric type and the resident
mezzanine cards fabric types do not match or are incompatible. 2) Invalid I/O Module and I/O
Module configuration, where a newly installed I/O Module has a different or incompatible
fabric type from an I/O Module already installed in the fabric.
Recommended
Response Action Refer to Chassis Management Controller Users Guide for additional information.
Category System Health
SubCategory CMC = Chassis Management Controller
Severity Severity 1 (Critical)
Trap/EventID 2545
LCD Message No LCD message display defined.
Initial Default. SNMP Alert;#EMAIL Alert;#LC Log;#Remote System Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE TRUE TRUE FALSE FALSE FALSE FALSE
CMC8516
Message The I/O Module arg1 did not boot within the expected time.
Arguments
• arg1 = iom slot name
Detailed
Description The I/O module may have taken more time to boot than was expected or the I/O module did not
boot.
Recommended
Response Action Verify the I/O Module is turned on using CMC Web Interface or RACADM CLI and retry the
operation. Otherwise, reinsert the I/O Module and retry the operation. If the problem persists,
contact technical support.
Category System Health
112