Dell PowerEdge VRTX - Manual (Page 762)

Arguments
• arg1 = profile name
• arg2 = slot number
Detailed
Description Unable to communicated with iDRAC.
Recommended
Response Action Check if iDRAC is ready and system is running properly. Utilize the RACADM command by
running "racadm getversion" to list all the servers and make sure the iDRAC version is
displayed. If the iDRAC is listed as Not Ready then wait until it becomes ready. A Virtual Reseat
may be required. The Lifecycle log in the server identified in the message may have additional
information about the inability of the iDRAC to apply Profile settings.
Category Audit
SubCategory SWC = Software Config
Severity Severity 1 (Critical)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. LC Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
SWC8510
Message Unable to apply arg1 Profile to requested Server(s)
Arguments
• arg1 = profile name
Detailed
Description Unable to communicate with the iDRAC of the requested Server.
Recommended
Response Action Check if iDRAC is ready and system is running properly. Utilize the RACADM command by
running "racadm getversion" to list all the servers and make sure the iDRAC version is
displayed. If the iDRAC is listed as Not Ready then wait until it becomes ready. A Virtual Reseat
may be required. The Lifecycle log in the server may have additional information about the
inability of the iDRAC to apply Profile settings.
Category Audit
SubCategory SWC = Software Config
Severity Severity 1 (Critical)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. LC Log
762