Dell PowerEdge VRTX - Manual (Page 772)

Recommended
Response Action Make sure the user name is valid. If communication with iDRAC is not successful, reset the
iDRAC. Retry the operation after a few minutes.
Category Audit
SubCategory SWC = Software Config
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. LC Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
SWC8528
Message Chassis Management Controller is unable to update the iDRAC root password.
Detailed
Description The Chassis Management Controller is unable to update the IDRAC "root" user password. This
can happen if the communction to the iDRAC from CMC is non-functional or if the password
entered is not valid.
Recommended
Response Action Make sure the password is valid. If communications with the iDRAC is not functioning, reset
the iDRAC and retry the operation after a few minutes. Run the RACADM command "racadm
ping server-<slot number> " to check the communications. If the communications are not
functional, restart the iDRAC by performing a Virtual Reseat of the server using the RACADM
command "racadm racreset -m server-<slot id>".
Category Audit
SubCategory SWC = Software Config
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. LC Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSE
SWC8529
Message Chassis Management Controller unable to enable the iDRAC root user.
Detailed
Description The Chassis Management Controller is unable to enable the iDRAC root user. This can happen
if the communction to the iDRAC from CMC is non-functional or iDRAC is rebooting
772