Dell PowerEdge VRTX - Manual (Page 182)

CTL42
Message Enclosure Management Module (EMM) hot plug is not supported on arg1 .
Arguments
• arg1 = Controller name
Detailed
Description An attempt to hot plug an Enclosure Management Module (EMM) has been detected.
Recommended
Response Action If the new enclosure and its device are not detected by the operating system, try restarting
your system to verify the newly attached enclosure and its sub-components are detected. See
the hardware documentation for more information.
Category Storage
SubCategory CTL = Storage Contr
Severity Severity 3 (Informational)
Trap/EventID 4331
LCD Message No LCD message display defined.
Initial Default. SNMP Alert;#LCD;#Remote System Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE TRUE TRUE TRUE FALSE FALSE FALSE
CTL43
Message Diagnostic message arg1 from arg2
Arguments
• arg1 = args
• arg2 = Controller name
Detailed
Description This alert is provided for informational purposes. The text for this alert is generated by the
utility that ran the diagnostics and can vary depending on the situation.
Recommended
Response Action No response action is required.
Category Storage
SubCategory CTL = Storage Contr
Severity Severity 3 (Informational)
Trap/EventID 4331
LCD Message No LCD message display defined.
Initial Default. SNMP Alert;#LCD;#Remote System Log
182