Dell PowerEdge VRTX - Manual (Page 321)

Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP014
Message Maximum jobs per queue exceeded.
Detailed
Description The number of jobs specified in the SetupJobQueue request combined with the existing job
count contains more jobs IDs than the maximum number of jobs supported by the system (256).
Completed jobs are automatically deleted if they are older than the delete on completion
timeout setting.
Recommended
Response Action Reduce the number of jobs specified in the operation or reduce the existing job count before
retrying the operation. Perform one of the following to reduce the job count: 1) Delete one or
more jobs and retry the operation. 2) Wait until existing jobs have an elapsed time since
completion that is greater than the delete on completion timeout setting and are automatically
deleted. 3) Change the delete on completion timeout setting to a smaller value so that
completed jobs are automatically deleted sooner.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP015
Message A running job cannot be deleted.
Detailed
Description The job is currently executing and cannot be deleted. The job needs to finish running, whether
successful or not, before it can be deleted.
Recommended
Response Action Wait for the job to have a completed job status. Retry the operation.
Category Configuration
321