Jcp016, Jcp017 – Dell PowerEdge VRTX User Manual
Page 322
SubCategory
JCP = Job Control
Severity
Severity 2 (Warning)
Trap/EventID
FALSE
LCD Message
No LCD message display defined.
Initial Default.
FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Alert
LC Log
LCD
Power Off Power
Cycle
Reset
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
JCP016
Message
Invalid UntilTime value. A minimum of 12 minutes is required.
Detailed
Description
The UntilTime input parameter for the job or job queue creation must be at least 12 minutes
after the value specified in the StartTime parameter.
Recommended
Response Action
Set the UntilTime at least 12 minutes after StartTime and retry.
Category
Configuration
SubCategory
JCP = Job Control
Severity
Severity 2 (Warning)
Trap/EventID
FALSE
LCD Message
No LCD message display defined.
Initial Default.
FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Alert
LC Log
LCD
Power Off Power
Cycle
Reset
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
JCP017
Message
Job creation request unsuccessful. Maximum number of jobs reached.
Detailed
Description
The current job count has reached the maximum value supported. No more jobs are created
until the number of jobs on the system is reduced. Completed jobs are automatically deleted if
they are older than the DeleteOnCompletionTimeout setting.
Recommended
Response Action
Perform one of the following to reduce the job count: 1) Delete one or more jobs and retry the
operation. 2) Wait until existing jobs have an elapsed time since completion that is greater than
the delete on completion timeout setting and are automatically deleted. 3) Change the delete
on completion timeout setting to a smaller value so that completed jobs are automatically
deleted sooner.
Category
Configuration
322