PLANET WGSW-50040 - Manual (Page 104)

Opening ports1/1-8.
Switch(config)#interface ethernet1/1-8
Switch(Config-Port-Range)#no shutdown
3.1.15 speed-duplex
Command:
speed-duplex {auto | force10-half | force10-full | force100-half | force100-full | force100-fx
[module-type {auto-detected | no-phy-integrated | phy-integrated}] | {{force1g-half |
force1g-full} [nonegotiate [master | slave]]}}
no speed-duplex
Function:
Sets the speed and duplex mode for 1000Base-TX, 100Base-TX or 100Base-FX ports; the “no
speed-duplex” command restores the default speed and duplex mode setting, i.e., auto speed
negotiation and duplex.
Parameters:
auto for auto speed negotiation;
force10-half for forced 10Mbps at half-duplex;
force10-full for forced 10Mbps at full-duplex mode;
force100-half for forced 100Mbps at half-duplex mode;
force100-full for forced 100Mbps at full-duplex mode;
force100-fx for forced 100Mbps at full-duplex mode;
module-type is the type of 100Base-FX module;
auto-detected: automatic to detect;
no-phy-integrated: there is no phy-integratd 100Base-TX module;
phy-integrated: phy-integratd 100Base-TX module;
force1g-half for forced 1000Mbps at half-duplex mode;
force1g-full for forced 1000Mbps at full-duplex mode;
nonegotiate for disable auto-negotiation for 1000 Mb port;
master to force the 1000Mb port to be master mode;
slave to force the 1000Mb port to be slave mode.
Command mode:
Port Mode.
Default:
Auto-negotiation for speed and duplex mode is set by default.
Usage Guide:
This command is configures the port speed and duplex mode. When configuring port speed and