PLANET WGSW-50040 - Manual (Page 136)

Default:
No MAC address joins the VLAN by default.
Usage Guide:
With this command user can add specified MAC address to specified VLAN. If there is a non VLAN
label data packet enters from the switch port from the specified MAC address, it will be assigned
with specified VLAN ID so sent enter specified VLAN. Their belonging VLAN are the same no
matter which port did they enter through. The command does not have any interfere on the VLAN
label data packet.
Example:
Add network device of MAC address as 00-30-4f-11-22-33 to VLAN 100.
Switch#config
Switch(config)#mac-vlan mac 00-30-4f-11-22-33 vlan 100 priority 0
7.2.4 mac-vlan vlan
Command:
mac-vlan vlan <vlan-id>
no mac-vlan vlan <vlan-id>
Function:
Configure the specified VLAN to MAC VLAN; the “no mac-vlan vlan <vlan-id>” command cancels
the MAC VLAN configuration of this VLAN.
Parameter:
<vlan-id> is the number of the specified VLAN.
Command Mode:
Global Mode.
Default:
No MAC VLAN is configured by default.
Usage Guide:
Set specified VLAN for MAC VLAN, There can be only one MAC VLAN at the same time.
Example:
Set VLAN100 to MAC VLAN.
Switch#config
Switch(config)#mac-vlan vlan 100
7.2.5 protocol-vlan