PLANET WGSW-50040 - Manual (Page 187)

the weight rotation management mode.
Example:
Configure the queue bandwidth as 10kbytes, 10kbytes, 20kbytes, 20kbytes, 30kbytes, 30kbytes,
40kbytes, 40kbytes.
Switch(interface-ethernet1/1)#mls qos queue weight 10 10 20 20 40 40 80 80
10.11 mls qos queue bandwidth
Command:
mls qos queue <queue-id> bandwidth <minimum-bandwidth> <maximum-bandwidth>
no mls qos queue <queue-id> bandwidth
Function:
After configure this command, the queue bandwidth guarantee is set.
Parameters:
<queue-id> is the queue ID to configure the bandwidth guarantee, the different chip supports the
different queue count, the range is different too, and the ranging from 1 to 8.
<minimum-bandwidth > is the minimum-bandwidth, ranging from 0 to 128000, when input 0, it
means the min-bandwidth function is not take effect.
<maximum-bandwidth > is the maximum-bandwidth, ranging from 0 to 128000, when input 0, it
means the max-bandwidth function is not take effect. The minimum-bandwidth must not bigger than
maximum-bandwidth.
Default:
The queue bandwidth have no guarantee.
Command mode:
Port Mode
Usage Guide:
The minimum-bandwidth guarantee and maximum-bandwidth limit can be configured at the different
or same queue. The queue bandwidth pledge for egress is relative to management mode, for
example: one port is the strict priority-queue, the highest priority is queue 1 now, it will satisfy this
queue traffic when block is happened. But if user want the lower priority of queue having bandwidth,
it can remain bandwidth via this command, the lower priority queue’s minimum-bandwidth will be
satisfied at first, then the excess bandwidth is managed according to SP.
Example:
Configure the minimum-bandwidth is 64kbps and the maximum-bandwidth is 128kbps for
ethernet1/2 queue1.