PLANET WGSW-50040 - Manual (Page 182)

flowlabel | vlan | cos}
Function:
Configure the match standard of the class map; the “no” form of this command deletes the specified
match standard.
Parameter:
access-group <acl-index-or-name> match specified IP ACL or MAC ACL, the parameters are the
number or name of the ACL;
ip dscp <dscp-list> and ipv6 dscp <dscp-list> match specified DSCP value, the parameter is a list
of DSCP consisting of maximum 8 DSCP values, the ranging is 0~63;
ip precedence <ip-precedence-list> match specified IP Precedence, the parameter is a IP
Precedence list consisting of maximum 8 IP Precedence values with a valid range of 0~7;
ipv6 access-group <acl-index-or-name> match specified IPv6 ACL, the parameter is the number
or name of the IPv6 ACL;
ipv6 flowlabel <flowlabel-list> match specified IPv6 flow label, the parameter is IPv6 flow label
value, the ranging is 0~1048575;
vlan <vlan-list> match specified VLAN ID, the parameter is a VLAN ID list consisting of maximum 8
VLAN IDs, the ranging is 1~4094;
<cost-list> match specified CoS value, the parameter is a CoS list consisting of maximum 8 CoS,
the ranging is 0~7.
Default:
No match standard by default
Command Mode:
Class-map Mode
Usage Guide:
Only one match standard can be configured in a class map. When configuring the match ACL,
permit rule as the match option, apply Policy Map action. Deny rule as the excluding option, do not
apply Policy Map action. If configure another match rule after one was configured, the operation
fails, but configure the same match rule will cover the previous.
Example:
Create a class-map named c1, and configure the class rule of this class-map to match packets with
IP Precedence of 0.
Switch(config)#class-map c1
Switch(Config-ClassMap-c1)#match ip precedence 0
Switch(Config-ClassMap-c1)#exit