PLANET WGSW-50040 - Manual (Page 89)

Hostname : LAB_SWITCH_2
Upstream local-port: eth 1/1
Upstream node: 01-02-03-04-05-01
Upstream remote-port:eth 1/2
Upstream speed: 100full
Switch#
----------------------------------------------
Switch#show cluster topology mac-address 01-02-03-04-05-02
Toplogy role: Member
Member status: Active member (user-config)
SN: 2
MAC Address: 01-02-03-04-05-02
Description: WGSW-50040
Hostname : LAB_SWITCH_2
Upstream local-port: eth 1/1
Upstream node: 01-02-03-04-05-01
Upstream remote-port:eth 1/2
Upstream speed: 100full
2.18 rcommand commander
Command:
rcommand commander
Function:
In the member switch, use this command to configure the commander switch.
Command mode:
Admin Mode.
Instructions:
This command is used to configure the commander switch remotely. Users have to telnet the
commander switch by passing the authentication. The command “exit” is used to quit the
configuration interface of the commander switch. This command can only be executed on member
switches.
Example:
In the member switch, enter the configuration interface of the commander switch.
Switch#rcommand commander