PLANET WGSW-50040 - Manual (Page 244)

Commands for Security Function Chapter 6 Commands for TACACS+
Configures the Domain name for DHCP clients; the “no domain-name” command deletes the
domain name.
Parameters:
<domain> is the domain name, up to 255 characters are allowed.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
Specifies a domain name for the client.
Example:
Specifying “digitalchina.com.cn" as the DHCP clients’ domain name.
Switch(dhcp-1-config)#domain-name digitalchina.com.cn
15.1.10 hardware-address
Command:
hardware-address <hardware-address> [{Ethernet | IEEE802|<type-number>}]
no hardware-address
Function:
Specifies the hardware address of the user when binding address manually; the “no
hardware-address” command deletes the setting.
Parameters:
<hardware-address> is the hardware address in Hex;
Ethernet | IEEE802 is the Ethernet protocol type,
<type-number> should be the RFC number defined for protocol types, from 1 to 255, e.g., 0 for
Ethernet and 6 for IEEE 802.
Default:
The default protocol type is Ethernet,
Command Mode:
DHCP Address Pool Mode
Usage Guide:
This command is used with the “host” when binding address manually. If the requesting client
hardware address matches the specified hardware address, the DHCP server assigns the IP
address defined in “host” command to the client.
Example:
Specify IP address 10.1.128.160 to be bound to the user with hardware address 00-00-e2-3a-26-04
in manual address binding.