PLANET WGSW-50040 - Manual (Page 354)

Commands for Security Function Chapter 6 Commands for TACACS+
Parameters:
<seconds> is the interval for re-authentication, in seconds, the valid range is 1 to 65535.
Command mode:
Global Mode.
Default:
The default value is 3600 seconds.
Usage Guide:
dot1x re-authentication must be enabled first before supplicant re-authentication interval can be
modified. If authentication is not enabled for the switch, the supplicant re-authentication interval set
will not take effect.
Example:
Setting the re-authentication time to 1200 seconds.
Switch(config)#dot1x timeout re-authperiod 1200
22.22 dot1x timeout tx-period
Command:
dot1x timeout tx-period <seconds>
no dot1x timeout tx-period
Function:
Sets the interval for the supplicant to re-transmit EAP request/identity frame; the “no dot1x timeout
tx-period” command restores the default setting.
Parameters:
<seconds> is the interval for re-transmission of EAP request frames, in seconds; the valid range is
1 to 65535.
Command mode:
Global Mode.
Default:
The default value is 30 seconds.
Usage Guide:
Default value is recommended.
Example:
Setting the EAP request frame re-transmission interval to 1200 seconds.
Switch(config)#dot1x timeout tx-period 1200