PLANET WGSW-50040 - Manual (Page 375)

Commands for Security Function Chapter 6 Commands for TACACS+
Switch(config)# dosattack-check icmpv6-size 100
Chapter 26 Commands for
TACACS+
26.1 tacacs-server authentication host
Command:
tacacs-server authentication host <ip-address> [port <port-number>] [timeout <seconds>]
[key <string>] [primary]
no tacacs-server authentication host <ip-address>
Function:
Configure the IP address, listening port number, the value of timeout timer and the key string of the
TACACS+ server; the no form of this command deletes TACACS+ authentication server.
Parameter:
<ip-address> is the IP address of the server;
<port-number> is the listening port number of the server, the valid range is 0~65535, amongst 0
indicates it will not be an authentication server;
<seconds> is the value of TACACS+ authentication timeout timer, shown in seconds and the valid
range is 1~60;
key <string> is the key string, containing maximum 16 characters;
primary indicates it’s a primary server.
Command Mode:
Global Mode
Default:
No TACACS+ authentication configured on the system by default.
Usage Guide:
This command is for specifying the IP address, port number, timeout timer value and the key string
of the TACACS+ server used on authenticating with the switch. The parameter port is for define an
authentication port number which must be in accordance with the authentication port number of
specified TACACS+ server which is 49 by default. The parameters key and timeout is used to
configure the self-key and self-timeout, if the switch is not configure the timeout<seconds> and
key<string>, it will use the global value and key by command tacacs-server timeout<seconds> and
tacacs-server key <string>. This command can configure several TACACS+ servers communicate
with the switch. The configuration sequence will be used as authentication server sequence. And in