PLANET WGSW-50040 - Manual (Page 364)

Commands for Security Function Chapter 6 Commands for TACACS+
Switch(config)# show mac-address dynamic count interface ethernet 1/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show mac-address dynamic count vlan 1
Vlan MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
1 55 15
-----------------------------------------------------------------------------------------------------
23.5 debug switchport mac count
Command:
debug switchport mac count
no debug switchport mac count
Function:
When the number limitation function debug of MAC on the port, if the number of dynamic MAC and
the number of MAC on the port is larger than the max number allowed, users will see debug
information.” no debug switchport mac count” command is used to disable the number limitation
function debug of MAC on the port.
Command Mode:
Admin Mode
Usage Guide:
Display the debug information of the number of dynamic MAC on the port.
Examples:
Switch#debug switchport mac count
%Jun 14 16:04:40 2007 Current mac count 21 is more than or equal to the maximum limit
in port Ethernet1/1
!!%Jun 14 16:04:40 2007 Mac learning will be stopped and some mac will be delete !!