PLANET WGSW-50040 - Manual (Page 41)

Command:
authentication securityip <ip
no authentication securityip <ip-addr>
Function:
To configure the trusted IP address for Telnet and HTTP login method. The no form of this command
will remove the trusted IP address configuration.
Parameters:
<ip-addr> is the trusted IP address of the client in dotted decimal format which can login the switch.
Default:
No trusted IP address is configured by default.
Command Mode:
Global Mode.
Usage Guide:
IP address of the client which can login the switch is not restricted before the trusted IP address is
not configured. After the trusted IP address is configured, only clients with trusted IP addresses are
able to login the switch. Up to 32 trusted IP addresses can be configured in the switch.
Example:
To configure 192.168.1.21 as the trusted IP address.
Switch(config)# authentication securityip 192.168.1.21
1.2.5 authentication securityipv6
Command:
authentication securityipv6 <ipv6-addr>
no authentication securityipv6 <ipv6-addr>
Function:
To configure the trusted IPv6 address for Telnet and HTTP login method. The no form of this
command will remove the specified configuration.
Parameters:
<ipv6-addr> is the trusted IPv6 address which can login the switch.
Default:
No trusted IPv6 addresses are configured by default.
Command Mode:
Global Mode.
Usage Guide:
IPv6 address of the client which can login the switch is not restricted before the trusted IPv6
address is not configured. After the trusted IPv6 address is configured, only clients with trusted IPv6