PLANET WGSW-50040 - Manual (Page 307)

Commands for Security Function Chapter 6 Commands for TACACS+
19.1.14 ipv6 mld snooping vlan static-group
Command:
ipv6 mld snooping vlan<vlan-id> static-group <X:X::X:X> [source< X:X::X:X>] interface
[ethernet | port-channel] <IFNAME>
no ipv6 mld snooping vlan <vlan-id> static-group <X:X::X:X> [source< X:X::X:X>] interface
[ethernet | port-channel] <IFNAME>
Function:
Configure static-group on specified port of the VLAN. The no form of the command cancels this
configuration.
Parameter:
vlan-id: ranging between <1-4094>
X:X::X:X:The address of group or source.
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
Command Mode:
Global Mode
Default:
No configuration by default.
Usage Guide:
When a group is a static while also a dynamic group, it should be taken as a static group. Deleting
static group can only be realized by the no form of the command.
Example:
Switch(config)#ip igmp snooping vlan 1 static-group ff1e::15 source 2000::1 interface
ethernet 1/1
19.1.15 ipv6 mld snooping vlan static-group
Command:
ipv6 mld snooping vlan<vlan-id> static-group <X:X::X:X> [source< X:X::X:X>] interface
[ethernet | port-channel] <IFNAME>
no ipv6 mld snooping vlan <vlan-id> static-group <X:X::X:X> [source< X:X::X:X>] interface
[ethernet | port-channel] <IFNAME>
Function:
Configure the suppression query time; the “no” form of this command restores the default value.
Parameter: